|
Written by Administrator
|
|
Friday, 22 April 2011 00:54 |
Shale shaker GNPS70-3S is high efficiency shaker. It is designed according to users’ actual demand based on modern technique and principle. GNPS70-3S takes advantage of double vibration motors in-phase principle. It holding ideal design on structure, and work steadily, operated lasting time without any problem, take rather little cost on maintenance. If choose proper model or parameters, it can work for many kinds of drilling fluid solids control. It is an ideal solution for Oil and gas drilling, HDD, Metallurgy, mining tail mud solids control.
GNPS70-3S shaker contains pedestal, shaker deck, tension wedge, shaker screen, rubber strip, deck adjustment device, baffle box, tension device, electric cabinet, vibration motor, damping spring. It can be used by single or designed as tandem and triplex shaker to be operated at drilling job site.
Features of GNPS70-3S Shale shaker
» GNPS70-3S Shale shaker is designed as double motors in-phase principle. The shale shaker will vibrate as elliptical, part of spare parts are interchangeable with international shale shaker.
|
|
Read more...
|
|
Written by Administrator
|
|
Friday, 22 April 2011 00:10 |
Centrifugal sand pump has been designed and developed for petroleum drill in solid control equipment. It adopts the axial sucking structure and all the hydraulic components are friction proof cast iron, which is suitable for delivering the corrosive liquids with suspended particles in well drilling or other similar liquids. When designing the sand pump. Its specifications were fully thought that the complete solid control equipment can work under the best operating mode. It is endowed with high communality of parts, operating reliability, durability and convenient maintenance etc.
Centrifugal Pump is ideal motivity supply for desander, desilter and jet mud mixer. Take the centrifugal pump in ZJ50 drilling mud treatment system as the example. There are 4 pumps and each of them plays the different roles.
Centrifugal pump for desander, desilter
The slurry after the vibrating processing flow into the 1# compartment of the treating tank waiting for the downstream treatment. Then the first pump will send the mud to the desander hydrocyclone from the 1# compartment, at a pressure of 0.25～0.40MPa , then ,the desander starts to work for the second class purification. The treated mud overflows to the 2# compartment. The second sand pump will send the mud to desilter hydrocyclone at a pressure of 0.25～0.40MPa. Thus the desilter starts to work for the third class purification.
Centrifugal pump for Jet mud mixer
After the centrifuge processing, the particles large than 7μm is almost separated out from the drilling fluids.
|
|
Read more...
|
|
<< Start < Prev 1 2 3 4 5 6 Next > End >>
|
|
Page 6 of 6 |
