Print

How to clean a decanter centrifuge

on . Posted in News

How to clean a decanter centrifuge?

 

The cleaning work of the decanter centrifuge in detail is to stop the centrifuge first, then close some corresponding valves, etc., open the clean water valve, and rinse with clean water for 3-5 minutes. Close the clean water valve, let the centrifuge run for a while and then stop it, so that the remaining water in the centrifuge will be discharged automatically. If the water is clear, it means that it is cleaned. If the water is very dirty, it means that it has not been cleaned, and it should continue until the water is clear.

The differential in the decanter centrifuge is the part that is prone to failure. The differential in the decanter centrifuge has abnormal noises during operation. Then, in the detailed reason, it is a problem with the differential, for example, there is a problem with the parts of the differential, or there is no Installation in place, etc., will cause the above problems. Therefore, before work, check the differential to prevent the above problems. There is always a day of failure, and the differential in the decanter is the part where it is prone to failure.

If the differential in the decanter centrifuge has abnormal noises during operation, then, in detail, it is a problem with the differential, such as a problem with the components of the differential, or If it is not installed in place, it will cause the above problems. Therefore, before work, check the differential to prevent the above problems.

The decanter centrifuge uses the principle of centrifugal sedimentation to separate the drilling suspension. The solid phase is pushed to the slag discharge port at the small end of the drum through the blade on the screw pusher, and the liquid phase is It flows out through the overflow hole at the big end of the drum. To achieve the purpose of continuous separation.